Field story · Union, Missouri

Dometic FreshJet furnace won't turn on? A Missouri repair shop used WalTech UST to fix it.

New AC on the roof. Cold RV. A furnace that would not kick on. Then one shop swapped the thermostat and sent us a text.

Read the text they sent
65 Dometic wall thermostat No furnace
WalTech UST 3.0 smart RV thermostat WalTech UST 3.0 Furnace on

30-second check

Does this sound like your RV?

Tap any that match.

Tap one to see if this is your problem.

What changed

It is not your furnace. It is who gets to decide.

New RV air conditioners use a newer gas called R32. Dometic's older rooftop AC, the Penguin II, has been discontinued, and the Dometic FreshJet took its place. With it came a new wall thermostat: the Dometic Connect Essential.

Here is the part that surprises people. The new thermostat decides where your heat comes from. You do not.

From Dometic's own manual Priority is given to heat pump operation (if equipped) or heat strip operation (if equipped) until the outdoor ambient temperature reaches near freezing, then the system automatically switches over to furnace operation (if equipped). ...will not provide or allow direct control over the heat source. Dometic Connect Essential operating manual. Link at the bottom of this page.

So on a chilly night that is not near freezing, you can ask for heat all you want. The furnace waits.

For some owners that is fine. For plenty of others, especially in bigger coaches with a heat pump and a furnace, it is a cold surprise.

You are not the only one

What owners are saying

These are real posts from the iRV2 owner forums. We did not write them and we did not edit them.

"It was a nightmare to deal with and doesn't even have controls for the furnace."

Owner of a 2016 Newmar Ventana, after two new FreshJet heat pumps. iRV2, September 2026.

"I thought I'd be able to call for heat pump and furnace at the same time. That's why this system is such a challenge!"

iRV2 member, October 2026.

"I have been fighting this thing for a week now."

Owner who replaced 26-year-old Dometic heat pumps with FreshJet units. iRV2, April 2026.

To be fair to Dometic: some owners report that Dometic sent updated control boards under warranty, and that fixed their lost-zone trouble. That is good. It does not add a furnace button.

The call from Missouri

"The Dometic version won't kick on the furnace."

That is how 3R RV Service Center, a repair shop in Union, Missouri, described the coach sitting in their bay. A Dometic FreshJet on the roof. A furnace that would not start from the wall thermostat.

We sent them a WalTech UST 3.0 to try. Their technician wired it in. Then he left us this voicemail.

Voicemail from the technician, 3R RV Service Center

"Everything works great. All the responses are good on the panel and everything kicks on the furnace whenever I ask for it. The split differential from the heat pump to the furnace kicks over good in about two to three degree split."

Text from 3R RV Service Center

It is working like it should
Need to advertise you have the fix for Dometic's problem

WalTech

We didnt know dometic had the problem till u told us. Tks!!

Real voicemail and texts, November 2026. Typos and all.

Why it worked

Same AC. Same furnace. Different thermostat.

Nothing on the roof changed. The shop only swapped what hangs on the wall.

It plugs into the wiring you already have.

Have a Dometic Connect Essential? Use Dometic's RJ45-to-RJ11 adapter, sold with the Connect Essential so older Dometic CCC thermostats still work. UST 3.0 plugs right into it.

You tell it what you have.

During setup you pick your Dometic system, for example heat pump and furnace. It takes a minute.

You pick the heat. Furnace only, or both.

Want just the furnace? Pick it. Want both? The heat pump does the easy work. When it falls behind, the furnace takes over. In the Missouri shop, that hand-off happened at about two to three degrees.

Then check it from your phone.

Wi-Fi control is included. No subscription. Built-in cellular is there if you camp without Wi-Fi, with an optional Cellular plan.

Dometic Connect Essential

  • Picks the heat source for you.
  • Furnace waits until it is near freezing outside.
  • No direct control over the heat source.

WalTech UST 3.0

  • You can pick furnace only, any time.
  • Furnace came on every time the tech asked for it.
  • Heat pump handed off to the furnace at about two to three degrees.
  • Works with Dometic FreshJet R32, single zone and multi-zone.

Left side: Dometic's operating manual. Right side: what 3R RV Service Center reported after their install, plus our compatibility list.

WalTech UST 3.0 is the only aftermarket thermostat for old and new RV ACs. Including the latest R32 models. Install takes 15 to 30 minutes.

One honest note. It is not for every RV. It does not work with variable-speed ACs, or with coaches where the AC is run from one central touch screen instead of a wall thermostat. Check compatibility before you buy. It takes 30 seconds.

Want your furnace back?

WalTech UST 3.0. $289. No subscription. No monthly bill on Wi-Fi. 1-year replacement warranty.

Not sure it fits? Text a photo of your wall thermostat to 1-844-WALTECH. Real people reply within 15 to 30 minutes, 8am to 8pm.

Quick answers

Questions people ask

Why won't my furnace turn on with a new Dometic FreshJet?

The Dometic Connect Essential thermostat picks the heat source for you. Dometic's manual says the heat pump or heat strip gets priority until it is near freezing outside. Only then does it switch to the furnace. So on a cool night that is not near freezing, the furnace may not come on when you expect it.

Can I choose furnace only on the Dometic Connect Essential?

No. Dometic's manual says the thermostat "will not provide or allow direct control over the heat source."

Can I pick furnace only on WalTech UST 3.0?

Yes. You choose the heat source. Furnace only, or heat pump with the furnace as backup.

Does WalTech UST 3.0 work with Dometic FreshJet R32?

Yes. Single zone and multi-zone, as long as the AC is run by a wall thermostat. It is not for variable-speed ACs or for RVs where the AC is run from one central touch screen.

Will it work in my Newmar?

If your Newmar has a Dometic wall thermostat, such as the 10-button or 12-button thermostat or the Connect Essential, yes. If your AC is run from one central touch screen, no. Not sure? Text a photo of your thermostat to 1-844-WALTECH.

Do I need an adapter?

On a Connect Essential system, yes. Use Dometic's RJ45-to-RJ11 adapter, sold with the Connect Essential so older Dometic CCC thermostats still work. UST 3.0 plugs right into it.

How long does it take, and what does it cost?

15 to 30 minutes. $289. No subscription and no monthly bill on Wi-Fi.

I run a repair shop. Can we talk?

Yes. Text us at 1-844-WALTECH and tell us what is in your bay.

Where this comes from
  1. Dometic Connect Essential operating manual: read the manual (PDF).
  2. iRV2 forum: thermostat trouble after a Penguin II to FreshJet swap.
  3. iRV2 forum: FreshJet thermostat and adapter problems.
  4. Voicemail and text messages from 3R RV Service Center, Union, Missouri, to WalTech, November 2026.

Dometic, FreshJet, Penguin and Connect Essential are trademarks of Dometic. Newmar is a trademark of Newmar Corporation. WalTech is not affiliated with either company.

← Back to all articles